Reelmaster 6500–D/6700–D
Page 8 – 18
Cutting Units
Rev. B
Model 03857, S/N 80001–80301
Model 03858, S/N 80001–81418
Model 03859, S/N 80001–81992
Bedknife Replacement and Grinding
1. Remove bedbar from cutting unit.
2. Remove bedknife screws and remove bedknife.
3. Remove all rust, scale and corrosion from bedbar sur-
face before installing new bedknife.
4. Install new bedknife:
A. Make sure bedbar threads are clean.
B. Use new screws. Apply anti–seize lubricant to
screw threads before installing.
C. Tighten screws to a torque of 250 – 300 in.lb.
(288 – 345 KgCm) working from the center toward
each end of the bedbar. DO NOT use an impact
wrench.
5. Since there can be variations in the mounting surface
of the bedbar, a new bedknife will not be perfectly flat af-
ter it is installed. Because of this, it is necessary to back-
lap or grind a new bedknife after installing it to the
bedbar. Follow the existing angle that was ground into
the bedknife and grind only enough to make sure the top
surface is true.
Regrinding Bedknife
Remove bedbar / bedknife assembly from cutting unit
before attempting to regrind a used bedknife. Keep the
bedknife fastened to the bedbar when grinding.
Note: When grinding, be careful to not overheat the
bedknife. Remove small amounts of material with each
pass of the grinder.
Bedknife Regrinding Specifications
Relief Angle
5
_
Relief Angle Range
3
_
– 6
_
Front Angle
15
_
Front Angle Range
13
_
– 17
_
1
2
4
6
8
3
5
7
Tighten screws to a torque of 250 –
300 in.lb. (288 – 345 KgCm) starting
in the middle of the bedknife.
Use a torque
wrench and
bedknife screw tool
Figure 24
Relief Angle
Front Angle
Top Face
Front
Face
Figure 25
Summary of Contents for REELMASTER 6500 D
