Reelmaster 6500–D/6700–D
Page 8 – 25
Cutting Units
Rev. B
Model 03857, S/N 80001–80301
Model 03858, S/N 80001–81418
Model 03859, S/N 80001–81992
6. Insert a thrust washer onto horizontal shaft of pivot
knuckle as shown in figure 32.
7. Insert the horizontal shaft of the pivot knuckle into the
mounting tube of the carrier frame (Fig. 32).
8. Secure pivot knuckle to carrier frame with a thrust
washer, flat washer and a flange head capscrew
(Fig. 32).
9. Insert a thrust washer onto vertical shaft of pivot
knuckle (Fig. 32).
10. Insert the vertical shaft of the pivot knuckle into lift
arm pivot hub (Fig. 32). Guide the pivot knuckle in place
between the two rubber centering bumpers in the under
side of the lift arm steering plate.
11. Insert the lynch pin into the cross hole on the pivot
knuckle shaft (Fig. 32).
12. Mount the motor to the drive end of the cutting unit
and secure with two capscrews provided (Fig. 33).
13. On front center and left rear cutting units, plug speed
sensor wire harness connector into traction unit wire
harness connector.
14. On motor side of cutting unit, insert speed sensor
end of harness through cutting unit rear frame tube and
route to counterweight.
15. Install small O–ring onto speed sensor and insert
sensor into hole in counterweight (Fig. 31).
16. Secure sensor to counterweight with a sensor holder
and a M6 x 20 mm capscrew (Fig. 31).
17. Insert steering pin into one of the following pivot
knuckle mounting locations (Fig. 32):
Rear Mounting Hole–Keeps cutting unit locked in
straight a line.
Front Mounting Hole–Allows cutting unit to steer itself as
traction unit turns.
18. Hook spring wire around bottom of steering pin (Fig.
32).
Figure 32
1. Carrier frame
2. Pivot knuckle
3. Lift arm steering plate
1
2
3
4. Lynch pin
5. Steering pin
5
4
Figure 33
1. Motor
2. O–ring
1
2
Cutting Units
03857, 03858, 03859
Summary of Contents for REELMASTER 6500 D
