control has 2 positions: Slow and Fast. The engine
speed can be varied between the 2 settings.
Note:
The engine cannot be stopped by the throttle
control.
Hour Meter
The hour meter (Figure 7), indicates the total hours of
machine operation. The hour meter starts to function
whenever the key switch is rotated to the On position.
Lift Lever
To raise the attachment, pull the lift lever (Figure 8)
back; to lower the attachment, push the lever forward.
For the float position, move the lever into the detent
position. When the desired position is attained, release
the lever and it will return to neutral.
g016653
Figure 8
1.
Lift lever
2.
Parking brake
Note:
The machine has a double-acting lift cylinder.
Down pressure can be applied to the attachment for
certain operating conditions.
Parking Brake
To engage the parking brake (Figure 8) pull back on
the parking brake lever. To disengage it, push the lever
forward.
Fuel Shutoff Valve
Close the fuel shutoff valve (Figure 9) when storing or
trailering the machine.
Figure 9
1.
Fuel shutoff valve
Seat Adjustment
Move the lever on the side of the seat outward, slide
the seat to the desired position, and release the lever to
lock the seat into position.
An additional 2-1/2 inches (64 mm) of forward
adjustment may be attained by, proceed as follows:
1. Remove the (4) locknuts securing the seat slides to
the seat plate.
2. Move the seat/slides to the forward set of mounting
holes in the seat plate.
3. Secure the seat slides to the seat plate with the
locknuts previously removed.
Specifications
Note:
Specifications and design are subject to change
without notice.
Width without attachment
57–1/2 inches (146 cm)
Width with rake, model number
08812
75 inches (191 cm)
Length without rake
76 inches (163 cm)
Height
45 inches (114 cm)
Wheelbase
42-3/4 inches (109 cm)
Net weight
834 lb. (378 kg)
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
14
Summary of Contents for Sand Pro 2020
Page 33: ...Schematics Electrical Schematic Rev A 33 ...
Page 34: ...Hydraulic Schematic Rev C 34 ...
Page 35: ...Notes 35 ...