Practice driving the machine because its operating
characteristics are different than some utility vehicles.
Two points to consider when operating the vehicle are
transmission and engine speed.
To maintain somewhat constant engine RPM, depress
the traction pedal slowly. This allows the engine to keep
up with the ground speed of the vehicle. By contrast,
pushing down quickly on the traction pedal will reduce
engine RPM and, as a result, there will not be enough
torque-power to move the vehicle. Therefore, to
transfer maximum power to the rear wheels, move
the throttle to Fast and slightly depress the traction
pedal. By comparison, maximum ground speed with no
load results when the throttle is in the Fast position
and the traction pedal is slowly but fully depressed. In
summary, always keep the engine RPM high enough to
deliver maximum torque-power to the rear wheels.
CAUTION
Operating the machine demands attention to
prevent tipping or loss of control.
•
Use care when entering and leaving sand traps.
•
Use extreme caution around ditches, creeks,
or other hazards.
•
Use caution when operating the machine on
a steep slope.
•
Reduce your speed when making sharp turns
or when turning on hillsides.
•
Avoid sudden stops and starts.
•
Do not go from reverse to full forward without
first coming to a complete stop.
19
Summary of Contents for Sand Pro 2020
Page 33: ...Schematics Electrical Schematic Rev A 33 ...
Page 34: ...Hydraulic Schematic Rev C 34 ...
Page 35: ...Notes 35 ...