Fuel System
Maintenance
Replacing the Fuel Filter
Service Interval:
Every 800 hours
An in line filter is incorporated into the fuel line. Change
the filter every 800 hours. Use the following procedures
when replacement becomes necessary:
1. Close fuel shut off valve, loosen the hose clamp on
the carburetor side of filter and remove the fuel line
from the filter (Figure 19).
G008963
1 2
3
Figure 19
1.
Fuel filter
3.
Fuel line
2.
Hose clamps
2. Place a drain pan under filter, loosen the remaining
hose clamp and remove filter.
3. Install the new filter with arrow on the filter body
pointing away from the fuel tank (toward carburetor).
4. Slide the hose clamps onto the ends of the fuel lines.
Push the fuel lines onto the fuel filter and secure
them with the hose clamps. Be sure that the arrow
on the side of the filter points toward the carburetor.
Electrical System
Maintenance
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Caring for the Battery
Service Interval:
Every 25 hours
The battery electrolyte level must be properly maintained
and the top of the battery kept clean. If the machine is
stored in a location where temperatures are extremely
high, the battery will run down more rapidly than if
the machine is stored in a location where temperatures
are cool.
DANGER
Battery electrolyte contains sulfuric acid which is a
deadly poison and causes severe burns.
•
Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and rubber gloves to protect
your hands.
•
Fill the battery where clean water is always
available for flushing the skin.
Keep the top of the battery clean by washing it
periodically with a brush dipped in ammonia or
bicarbonate of soda solution. Flush the top surface with
water after cleaning. Do not remove the fill cap while
cleaning.
The battery cables must be tight on the terminals to
provide good electrical contact.
25
Summary of Contents for Sand Pro 2020
Page 33: ...Schematics Electrical Schematic Rev A 33 ...
Page 34: ...Hydraulic Schematic Rev C 34 ...
Page 35: ...Notes 35 ...
