Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Torque the wheel lug nuts.
• Change the engine oil and filter.
• Change the hydraulic filter.
Before each use or daily
• Check the engine oil level.
• Check the hydraulic fluid level.
• Check the tire pressure.
• Check the condition of the hydraulic lines and hoses.
• Inspect and clean the machine.
• Check the safety interlock operation
Every 25 hours
• Grease the front wheel bearings
• Check the battery fluid level and the cable connections.
Every 50 hours
• Change the engine oil and filter.
Every 100 hours
• Torque the wheel lug nuts.
• Grease the steering shaft and sprocket
Every 200 hours
• Replace the air filter.
Every 400 hours
• Change the hydraulic system oil and filter.
Every 800 hours
• Replace the spark plugs.
• Replace the fuel filter.
• Decarbon the combustion chamber.
• Adjust the valves and torque head.
• Check the engine RPM (at idle and full throttle).
• Drain and clean the fuel tank.
Every 1,500 hours
• Replace moving hoses.
• Replace the neutral and seat interlock switches.
Important:
Refer to your
Engine Operator’s Manual
for additional maintenance procedures.
20
Summary of Contents for Sand Pro 2020
Page 33: ...Schematics Electrical Schematic Rev A 33 ...
Page 34: ...Hydraulic Schematic Rev C 34 ...
Page 35: ...Notes 35 ...