2
3
4
5
6
2
3
4
5
6
1
G014459
Figure 13
1.
Control panel
4.
Fast
2.
Throttle/choke
lever—choke position
5.
Continuous variable
setting
3.
Choke
6.
Slow
4. Turn the ignition key to Start to energize the starter.
When the engine starts, release the key (Figure 14).
Important:
Do not engage the starter for more
than 10 seconds at a time. If the engine fails
to start, allow a 60 second cool-down period
between attempts. Failure to follow these
instructions can damage the starter motor.
1
2
3
4
5
6
4
5
6
G014460
Figure 14
1.
Control panel
4.
Off
2.
Ignition key—run position
5.
Run
3.
Ignition key—start position
6.
Start
5. After the engine starts, move the throttle lever to
Fast (Figure 13). If the engine stalls or hesitates,
move the throttle lever back to Choke for a few
seconds. Repeat this as required.
Operating the Blades
The blade control switch, represented by a power
take-off (PTO) symbol, engages and disengages power
to the mower blades. This switch controls power to any
attachments that draw power from the engine, including
the mower deck and cutting blades.
Engaging the Blades
Important:
Do not engage the blades when
parked in tall grass. Belt or clutch damage can
occur.
1. Release pressure on the motion control levers and
place the machine in neutral.
2. Move the throttle to the Fast position.
Note:
Always engage the blades with the throttle
in the Fast position.
3. Pull up on the blade control switch to move it to
the On position and engage the blades (Figure 15).
17
Summary of Contents for SS 3200
Page 46: ...Schematics G014644 Electrical Diagram Rev A 46 ...
Page 47: ...Notes 47 ...
