1. Press the bulb into the fixture contacts.
2. Snap the silver reflector into the clear lens.
3. Install the fixture lens/reflector.
Install the clear lens/reflector by pushing down on the lens with
slight pressure while turning the lens clockwise. The tabs on the
lens will snap into the three slots on the fixture. Turn the lens until
the movement stops.
INSTALLATION
GUIDE
FORM NO. 3315-919
MODEL NO. 52201 39000001 & Up
Style Lites™ Floodlights
®
4. Prepare the stake.
Loop the cable around the channels in the stake. Make certain the
cable is centered around the stake head and is tight. If the cable is
loose, pull the ends to eliminate the slack.
Imprinted
triangles
6. Align the side of the stake with the imprinted triangle to
the top of the fixture head with the imprinted triangle.
5. Make sure the piercing points in the fixture are
straight.
Make sure the brass piercing points in the cable channel at
the base of the fixture
are straight
. Even a slight bend may
result in contact not being made with the wire.
Misaligned
Piercing
Points
Correct
Piercing
Points
The most important
part of installing the
fixtures is making
sure their metal pins
pierce the wire inside
the cable:
You’ll know they’re
well-aligned and the
wire was pierced
when the light
comes on.
This
Not This
