Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
Note:
The grass bag may remain on the machine
while you are recycling the clippings.
To recycle the clippings, move the bag-on-demand
lever to the R
ECYCLING
position (
).
g012135
Figure 17
1.
R
ECYCLING
position
2.
B
AGGING
position
Bagging the Clippings
Use the grass bag to collect grass and leaf clippings
from the lawn.
WARNING
A worn grass bag could allow small stones
and other similar debris to be thrown toward
you or bystanders, resulting in serious
personal injury or death.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Shut off the engine and wait for all moving
parts to stop before leaving the operating
position.
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Install the grass bag; refer to
and move the bag-on-demand
lever to the
BAGGING
position as shown in
Installing the Grass Bag
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Raise and hold up the rear deflector, install the
bag in the notches, and lower the rear deflector
(
).
g014468
Figure 18
12
