TDC+ QUICK START GUIDE
Page 15
/ 20
SETUP FOR TWO-WIRE OPERATIONS (Important)
For proper operation of a TDC+ Two-Wire Decoder System, there are some additional steps that
need to be completed:
1.
Under the
Setup
Directory, Click on
Zone Data
.
Note: The Zone Data Screen shows a spreadsheet-like detail on individual station
information. You can enter a Type and Description for each station to aid identification, but
it is not required.
2.
On the Top of Zone Data Select
Setup Toro 2-Wire.
This sets all stations as Toro 2-Wire
stations.
For Each Two-Wire Station
3.
For each station, you must enter the 6-digit alphanumeric address of the decoder as:
a.
Device Precode
= First 3 Characters of Decoder Address
b.
Map Unit
= Last 3 Characters of Decoder Address
4.
Decoders can have 1, 2, or 4 Outputs. Assign a station to Decoder Output # of the decoder by
setting
Map Station = #
(where # = 1, 2, 3, or 4, corresponding to the decoder output).
