Toro Tempus Air BW
4.
The message indicate
that the LoRa
TM
connection
between the Tempus Air BW
and the module is reliable
.
3.
Push the red
button to test the
connection LoRa
TM
If the connection is not established, a "No connection established" message appears. Repeat this test several
times to confirm that the connection cannot be made. In this case, the distance between the Tempus Air BW
and the Tempus Air module will need to be reduced.
1.
Enter the Tempus Air
module in Bluetooth®
Then in the parameters
(small pencil at the top right)
2.
Push on « Remote access »
Step 4
LoRa
TM
TEST CONNECTION
If the association of the modules is carried out before the final installation of the Tempus Air BW, this connection
test can be used to validate the positioning of the latter by going to temporarily install the Tempus Air BW in its
intended location then by going to position a module in each of the valve boxes to verify good communication
with the Tempus Air BW. The connection test can also allow you to verify at any time the correct operation of the
LoRa
TM
radio between your module and the Tempus Air BW.
(Example: the product fell into the upside-down valve box and no longer communicates with the Tempus Air
BW). To test the LoRa
TM
connection, do the following:
6
