Installing the Side LED
Light
1.
Secure the side light bracket to the platform
using 2 self-tapping hex washer-head bolts as
shown in
.
g210264
Figure 5
1.
Platform
3.
Self-tapping hex
washer-head bolt
2.
Side light bracket
2.
Insert the hex-head bolt (5/16 x 3/4 inch) through
the LED light and side light bracket, and secure
it with the flange nut (5/16 inch) as shown in
g210263
Figure 6
1.
Flange nut (5/16 inch)
3.
Side light bracket
2.
Hex-head bolt (5/16 x 3/4
inch)
4.
LED light
Install the Light Switch
1.
Install the light switch bracket using the 2
self-tapping screws (#10 x 1/2 inch) as shown
in
g210324
Figure 7
1.
Light switch bracket
2.
Self-tapping screw (#10 x
1/2 inch)
2.
Insert the rocker switch into the light switch
bracket (
3.
Apply the light switch decal to the light switch
bracket (
g210323
Figure 8
1.
Light switch bracket
3.
Rocker switch
2.
Light switch decal
4.
Connect the wire-harness connector to the back
of the rocker switch.
4
Summary of Contents for TimeCutter 136-7493
Page 11: ...Notes ...
Page 12: ......
