WARNING
The spring is under tension when
installed and can cause personal injury.
Be careful when removing the belt.
g298026
Figure 50
1.
Idler pulley
4.
Spring
2.
Mower belt
5.
Engine pulley
3.
Outside pulley
6.
Spring-removal tool
6.
Route the new belt around the engine pulley and
mower pulleys (
).
7.
Using a spring-removal tool (Toro Part No.
92-5771), install the idler spring over the deck
hook and place tension on the idler pulley and
the mower belt (
8.
Install the pulley covers.
Mower Maintenance
Blade Safety
•
Inspect the blades periodically for wear or damage.
•
Use care when checking the blades. Wrap the
blades or wear gloves, and use caution when
servicing the blades. Only replace or sharpen the
blades; never straighten or weld them.
•
On multi-bladed machines, take care as rotating
one blade can cause other blades to rotate.
•
Replace worn or damaged blades and bolts in sets
to preserve balance.
Servicing the Cutting
Blades
To ensure a superior quality of cut, keep the blades
sharp. For convenient sharpening and replacement,
keep extra blades on hand.
Before Inspecting or Servicing the
Blades
1.
Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
ARK
position.
2.
Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
Inspecting the Blades
Service Interval:
Before each use or daily
1.
Inspect the cutting edges (
2.
If the edges are not sharp or have nicks, remove
and sharpen the blade; refer to
.
3.
Inspect the blades, especially in the curved area.
4.
If you notice any cracks, wear, or a slot forming
in this area, immediately install a new blade
(
).
42
Summary of Contents for TimeCutter 5000C
Page 54: ...Schematics g307974 Electrical Diagram 139 2356 Rev A 54 ...
Page 55: ...Notes ...
