Installing the Blades
1.
Install the blade onto the spindle shaft (
Important:
The curved part of the blade
must be pointing upward toward the inside
of the mower to ensure proper cutting.
2.
Install the curved washer (cupped side toward
the blade) and the blade bolt (
).
3.
Torque the blade bolt to 81 to 108 N∙m (60 to
80 ft-lb).
Leveling the Mower Deck
Check to ensure that the mower deck is level any time
you install the mower or when you see an uneven cut
on your lawn.
Check the mower deck for bent blades prior to
leveling, and remove and replace any bent blades;
refer to the
Servicing the Cutting Blades (page 42)
before continuing.
Level the mower deck side-to-side first; then you can
adjust the front-to-rear slope.
Requirements:
•
The machine must be on a level surface.
•
All tires must be properly inflated; refer to
the Tire Pressure (page 40)
.
Checking the Side-to-Side Level
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
ARK
position.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Set the height of cut to 76 mm (3 inches).
4.
Carefully rotate the blades side to side.
5.
Measure between the outside cutting edges and
the flat surface (
Note:
If both measurements are not within 5
mm (3/16 inch), an adjustment is required; refer
to
Leveling from Side to Side (page 46)
.
g296913
Figure 59
1.
Blades side to side
3.
Measure from the tip of the
blade to the flat surface
here.
2.
Outside cutting edges
Checking the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
7.9 mm (5/16 inch) lower than the rear of the mower,
adjust the blade level.
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
ARK
position.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Set the height of cut to 76 mm (3 inches).
4.
Carefully rotate the blades so they are facing
front to rear (
5.
Measure from the tip of the front blade to the
flat surface and the tip of the rear blade to the
flat surface (
Note:
If the front blade tip is not 1.6 to 7.9 mm
(1/16 to 5/16 inch) lower than the rear blade
tip, continue to the
Blade Slope (page 47)
procedure.
45
Summary of Contents for TimeCutter 5000C
Page 54: ...Schematics g307974 Electrical Diagram 139 2356 Rev A 54 ...
Page 55: ...Notes ...
