g296914
Figure 60
1.
Blades front to rear
3.
Measure from the tip of the
blade to the flat surface
here.
2.
Outside cutting edges
Leveling from Side to Side
1.
Move to the left side of the machine.
2.
Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to
Adjusting the Anti-Scalp Rollers (page 25)
.
3.
Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page 25)
.
4.
Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets (
5.
Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck (
g298028
Figure 61
1.
Wood block—6.6 cm
(2-5/8 inches) thick
2.
Wood block—7.3 cm
(2-7/8 inches) thick
6.
Remove the hairpin cotter and washer from the
lower lift-arm pin (
).
g294197
Figure 62
1.
Height-of-cut plate
3.
Washer
2.
Hairpin cotter
7.
Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate (
46
Summary of Contents for TimeCutter 5000C
Page 54: ...Schematics g307974 Electrical Diagram 139 2356 Rev A 54 ...
Page 55: ...Notes ...