g014635
Figure 65
1.
Front support rod
3.
Deck bracket
2.
Locking nut
5.
Carefully lower the front of the mower deck to
the ground.
6.
On 1 side of the machine, remove the washer
and hairpin cotter from the deck pin (
g295768
Figure 66
1.
Lift arm
3.
Washer
2.
Hairpin cotter
7.
Remove the lift arm from the deck pin (
8.
Repeat steps
and
for the other side of the
machine.
9.
Slide the mower deck rearward to remove the
mower belt from the engine pulley.
10.
Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Installing the Mower Deck
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
ARK
position.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Slide the mower under the machine.
4.
Lower the height-of-cut lever to the lowest
position.
5.
On 1 side of the machine, lift the rear of the
mower deck and install the lift arm to the deck
pin (
).
6.
Install the lift arm using the washer and hairpin
cotter (
).
7.
Repeat steps
and
for the other side of the
machine.
8.
Attach the front support rod to the mower deck
with the clevis pin and hairpin cotter (
).
9.
Install the mower belt onto the engine pulley;
refer to
Replacing the Mower Belt (page 41)
.
Replacing the Grass
Deflector
Service Interval:
Before each use or daily—Inspect
the grass deflector for damage.
WARNING
An uncovered discharge opening could allow
the machine to throw objects toward you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
Never operate the machine without the
grass deflector, the discharge cover, or the
grass-collection system in place.
1.
Remove the nut (3/8 inch) from the rod under
the mower (
).
48
Summary of Contents for TimeCutter 5000C
Page 54: ...Schematics g307974 Electrical Diagram 139 2356 Rev A 54 ...
Page 55: ...Notes ...
