3.
Select a hole in the height-of-cut system
corresponding to the desired height of cut and
insert the pin (
4.
Push on the deck-lift pedal with your foot and
pull the handle rearward to disengage the
transport lock (
).
5.
Lower the deck slowly until the lever makes
contact with the pin.
g188850
Figure 28
1.
Deck-lift pedal
3.
Pin
2.
Handle
4.
Height-of-cut positions
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1.
Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to
(page 20)
.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown in
g029955
Figure 29
1.
Anti-scalp roller
4.
Flange nut
2.
Spacer
5.
Bolt
3.
Bushing
26
