Using the Foot Pedal Deck-Lift
System
•
Press the deck-lift pedal down to raise the deck;
continue to press the pedal until the deck locks in
the transport position (
).
•
Push on the deck-lift pedal with your foot and pull
the transport lock handle rearward to disengage
the transport lock (
).
g024409
Figure 25
Transport Lock Position
Adjusting the Height of Cut
You can adjust the height of cut from 38 to 114 mm
(1-1/2 to 4-1/2 inches) in 6 mm (1/4 inch) increments
by moving the height-of-cut pin into different hole
locations.
1.
Push on the deck-lift pedal with your foot and
raise the mower deck to the transport-lock
position (also the 114 mm (4-1/2 inch) cutting
height position) as shown in
2.
To adjust, remove the pin from the height-of-cut
bracket (
).
3.
Select a hole in the height-of-cut system
corresponding to the desired height of cut and
insert the pin (
4.
Push on the deck-lift pedal with your foot and
pull the handle rearward to disengage the
transport lock (
).
5.
Lower the deck slowly until the lever makes
contact with the pin.
g188850
Figure 26
1.
Deck-lift pedal
3.
Pin
2.
Handle
4.
Height-of-cut positions
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1.
Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to
(page 17)
.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown in
g029955
Figure 27
1.
Anti-scalp roller
4.
Flange nut
2.
Spacer
5.
Bolt
3.
Bushing
22
Summary of Contents for TimeCutter HD X4850
Page 54: ...Schematics g203461 Electrical Diagram Rev A 54 ...
Page 55: ...Notes ...
