Checking the Engine-Oil Level
Service Interval:
Before each use or daily
Note:
Check the oil when the engine is cold.
Important:
If you overfill or underfill the engine
crankcase with oil and run the engine, you may
damage the engine.
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Note:
Ensure that the engine is cool so that the
oil has had time to drain into the sump.
3.
To keep dirt, grass clippings, etc., out of the
engine, clean the area around the oil-fill cap and
dipstick before removing it (
g235263
Figure 45
Changing the Engine Oil and Oil
Filter
Service Interval:
After the first 5 hours/After the
first month (whichever comes
first)—Change the engine oil and
filter.
Every 100 hours/Yearly (whichever comes
first)—Change the engine oil and oil filter (more
often in dirty or dusty conditions).
1.
Park the machine on a level surface to ensure
that the oil drains completely.
2.
Disengage the blade-control switch (PTO) and
engage the parking brake.
3.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4.
Drain the oil from the engine.
34
Summary of Contents for TimeCutter HD X4850
Page 54: ...Schematics g203461 Electrical Diagram Rev A 54 ...
Page 55: ...Notes ...
