Driving Backward
Note:
Always use caution when backing up and turning.
1.
Move the levers to the center, unlocked position.
2.
To go backward, look behind you and down, as you
slowly pull the motion-control levers rearward (
G008953
Figure 17
To go straight, apply equal pressure to both
motion-control levers (
To turn, release the pressure on the motion-control
lever toward the direction you want to turn.
To stop, push the motion-control levers to neutral.
Stopping the Machine
To stop the machine, move the motion-control levers to
neutral and outward to the P
ARK
position, disengage the
blade-control switch, ensure the throttle is in the F
AST
position, and turn the ignition key to O
FF
. Remember to
remove the key from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion-control levers outward to the P
ARK
position
when leaving the machine unattended, even if just
for a few minutes.
Adjusting the Height-of-Cut
Note:
The T
RANSPORT
position is the highest height-of-cut
position or cutting height (115 mm (4.5 inches)) as shown
in
.
Height-of-cut is controlled by the lever located to the right of
the operating position (
).
Figure 18
21
Summary of Contents for TimeCutter SS 5000
Page 49: ...Schematics Electrical Diagram Rev A 49 ...
Page 50: ...Notes 50 ...
Page 51: ...Notes 51 ...
