WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
•
Use extreme caution when operating a
machine on a ramp.
•
Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
•
Do not exceed a 15-degree angle between
the ramp and the ground or between the
ramp and the trailer or truck.
•
Ensure that the length of the ramp is at
least 4 times as long as the height of the
trailer or truck bed to the ground. This
ensures that the ramp angle does not
exceed 15 degrees on flat ground.
•
Back up the ramp and drive forward down
the ramp.
•
Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
g027996
Figure 22
1.
Full-width ramp in stowed
position
4.
Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
2.
Side view of full-width
ramp in loading position
5.
H= height of the trailer or
truck bed to the ground
3.
Not greater than
15 degrees
6.
Trailer
27
Summary of Contents for TimeCutter SW 5000
Page 52: ...Schematics g027754 Electrical Diagram Rev A 52 ...
Page 53: ...Notes ...
Page 54: ...Notes ...
Page 55: ...Notes ...
