Mower Maintenance
Servicing the Cutting
Blades
Maintain sharp blades throughout the cutting season,
because sharp blades cut cleanly without tearing or
shredding the grass blades. Tearing and shredding
turns grass brown at the edges, which slows growth,
and increases the chance of disease.
Check the cutter blades daily for sharpness, and
for any wear or damage. File down any nicks and
sharpen the blades as necessary. If a blade is
damaged or worn, replace it immediately with a
genuine Toro replacement blade. For convenient
sharpening and replacement, you may want to keep
extra blades on hand.
WARNING
A worn or damaged blade can break, and a
piece of the blade could be thrown into the
operator's or bystander's area, resulting in
serious personal injury or death.
•
Inspect the blade periodically for wear or
damage.
•
Replace a worn or damaged blade.
Before Inspecting or Servicing the
Blades
Park the machine on a level surface, disengage the
blade-control switch, ensure the parking brake is
engaged, shut off the engine, and remove the key.
Inspecting the Blades
Service Interval:
Before each use or daily—Check
the cutting blades.
1.
Inspect the cutting edges (
Note:
If the edges are not sharp or have
nicks, remove and sharpen the blades; refer to
Sharpening the Blades (page 42)
.
2.
Inspect the blades, especially the curved area
(
).
Note:
If you notice any damage, wear, or a
slot forming in this area (item 3 in
),
immediately install a new blade.
g006530
Figure 42
1.
Cutting edge
3.
Wear/slot forming
2.
Curved area
4.
Damage
Checking for Bent Blades
Note:
The machine must be on a level surface for
the following procedure.
1.
Raise the mower deck to the highest
height-of-cut position; also considered the
'transport' position.
2.
While wearing thickly padded gloves, or other
adequate hand protection, slowly rotate the
blade to be measure into a position that allows
effective measurement of the distance between
the cutting edge and the level surface the
machine is on (
).
g014972
Figure 43
1.
Deck
3.
Blade
2.
Spindle housing
40
Summary of Contents for TimeCutter SW 5000
Page 52: ...Schematics g027754 Electrical Diagram Rev A 52 ...
Page 53: ...Notes ...
Page 54: ...Notes ...
Page 55: ...Notes ...
