DANGER
A child or bystander could be backed over by a
riding mower with blades engaged and cause
serious personal injury or death.
•
Do not mow in reverse unless absolutely
necessary.
•
Always look backward and down before backing
up.
•
Use the KeyChoice switch only if you are certain
no children or other bystanders will appear in
the mowing area.
•
Always remove both the ignition and KeyChoice
keys and put them in a safe place out of the
reach of children or unauthorized users when
leaving the unit unattended.
If you are certain that you can safely mow or operate an
attachment in reverse, complete the following procedure:
1.
Insert the KeyChoice key into the KeyChoice switch
(
2.
Engage the PTO.
3.
Turn the KeyChoice key clockwise until it stops and
release it.
Note:
A red light illuminates on the console to serve
as a reminder that the interlock has been deactivated.
4.
Perform the mowing.
5.
When finished mowing, remove the KeyChoice key
(
Note:
Once you deactivate the interlock, it stays in
this mode—with your mower blade or PTO powered
attachment operating whenever you back up—and the
console light stays on until you either disengage the
PTO or turn off the engine.
Adjusting the Height-of-Cut
Note:
The transport position is the highest height-of-cut
position or cutting height 115 mm (4.5 inches) as shown in
.
Figure 15
Positioning the Steering Wheel
The steering wheel has 3 positions for operation and one,
full-up position. Use the full-up position for stepping on and
off the machine and getting out of the seat. When operating
the machine, position the steering wheel where you have the
best control of the machine and are most comfortable.
1.
Press your foot onto the steering-column release lever.
2.
Position the steering wheel to the desired position
(
).
20
Summary of Contents for TimeCutter SWX 5050
Page 50: ...Schematics Electrical Diagram Rev A 50 ...
Page 51: ...Notes 51 ...
