g027996
5
1
2
6
Figure 22
1.
Full-width ramp in stowed
position
4.
Ramp is at least four times
(4X) as long as the height
of the trailer or truck bed
to the ground
2.
Side view of full-width
ramp in loading position
5.
H= height of the trailer or
truck bed to the ground
3.
Not greater than
15 degrees
6.
Trailer
Operating Tips
Using the Fast Throttle Setting
For best mowing and maximum air circulation, operate
the engine at the Fast throttle position. Air is required to
thoroughly cut grass clippings, so do not set the height-of-cut
so low as to totally surround the mower by uncut grass.
Always try to have one side of the mower free from uncut
grass, which allows air to be drawn into the mower.
Cutting a Lawn for the First Time
Cut grass slightly longer than normal to ensure that the
cutting height of the mower does not scalp any uneven
ground. However, the cutting height used in the past is
generally the best one to use. When cutting grass longer than
six inches tall, you may want to cut the lawn twice to ensure
an acceptable quality of cut.
Cutting 1/3 of the Grass Blade
It is best to cut only about 1/3 of the grass blade. Cutting
more than that is not recommended unless grass is sparse, or
it is late fall when grass grows more slowly.
Mowing Direction
Alternate the mowing direction to keep the grass standing
straight. This also helps disperse clippings which enhances
decomposition and fertilization.
Mowing at Correct Intervals
Normally, mow every 4 days. But, remember, grass grows at
different rates at different times. So to maintain the same
cutting height, which is a good practice, and mow more often
in early spring. As the grass growth rate slows in mid summer,
mow less frequently. If you cannot mow for an extended
period, first mow at a high cutting height, then mow again 2
days later at a lower height setting.
Avoiding Cutting Too Low
If the cutting width of the mower is wider than the mower
you previously used, raise the cutting height to ensure that
uneven turf is not cut too short.
Cutting Long Grass
If the grass is ever allowed to grow slightly longer than
normal, or if it contains a high degree of moisture, raise the
cutting height higher than usual and cut the grass at this
setting. Then cut the grass again using the lower, normal
setting.
Stopping
If you must stop the machine's forward motion while mowing,
a clump of grass clippings may drop onto your lawn. To avoid
24
Summary of Contents for TimeCutter SWX 5050
Page 50: ...Schematics Electrical Diagram Rev A 50 ...
Page 51: ...Notes 51 ...
