WARNING
Loading a machine onto a trailer or truck increases
the possibility of tip-over and could cause serious
injury or death.
•
Use extreme caution when operating a machine
on a ramp.
•
Use only a full-width ramp; do not use individual
ramps for each side of the machine.
•
Do not exceed a 15-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
•
Ensure the length of ramp is at least four times
(4X) as long as the height of the trailer or truck
bed to the ground. This will ensure that ramp
angle does not exceed 15 degrees on flat ground.
•
Back up ramps and drive forward down ramps.
•
Avoid sudden acceleration or deceleration while
driving the machine on a ramp as this could
cause a loss of control or a tip-over situation.
g027996
5
1
2
6
Figure 33
1.
Full-width ramp in stowed
position
4.
Ramp is at least four times
(4X) as long as the height
of the trailer or truck bed
to the ground
2.
Side view of full-width
ramp in loading position
5.
H= height of the trailer or
truck bed to the ground
3.
Not greater than
15 degrees
6.
Trailer
30
Summary of Contents for timecutter zs 4200t
Page 55: ...Schematics Electrical Diagram Rev A 55 ...
Page 56: ...Notes 56 ...
Page 57: ...Notes 57 ...
Page 58: ...Notes 58 ...
