7.
Using a spring-removal tool (Toro part no. 92-5771),
install the idler spring over the deck hook, and place
tension on the idler pulley and mower belt ((
and
).
8.
Tighten the bottom two bolts holding the mower-deck
curtain to the mower deck. Refer to
Mower-Deck Curtain (page 33)
.
Cleaning
Washing the Underside of the
Mower
Service Interval:
After each use—Clean the mower-deck
housing.
Wash the underside of the mower after each use to prevent
grass buildup for improved mulch action and clipping
dispersal.
Important:
You can wash the machine with a mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, under the seat, around the engine, hydraulic
pumps, and motors.
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Attach the hose coupling to the end of the mower
washout fitting, and turn the water on high (
Note:
Spread petroleum jelly on the washout fitting
O-ring to make the coupling slide on easier and protect
the O-ring.
Figure 71
1.
Washout fitting
3.
O-ring
2.
Hose
4.
Coupling
4.
Lower the mower to the lowest height-of-cut.
5.
Sit on the seat and start the engine.
6.
Engage the blade-control switch and let the mower run
for 1 to 3 minutes.
7.
Disengage the blade-control switch, stop the engine,
remove the ignition key, and wait for all moving parts
to stop.
50
Summary of Contents for timecutter zs 4200t
Page 55: ...Schematics Electrical Diagram Rev A 55 ...
Page 56: ...Notes 56 ...
Page 57: ...Notes 57 ...
Page 58: ...Notes 58 ...
