Replacing the Grass Deflector
Service Interval:
Before each use or daily—Inspect the grass
deflector for damage.
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur. Never
operate the machine without the grass deflector,
the discharge cover, or the grass-collection system
in place.
Never operate the machine without the grass
deflector, the discharge cover, or the grass-collection
system in place.
Inspect the grass deflector for damage before each use.
Replace any damaged parts before use.
1.
Remove the nut (3/8 inch) from the rod under the
mower (
G005192
1
2
3
4
5
6
7
Figure 68
1.
Mower deck
5.
Spring
2.
Grass deflector
6.
Nut (3/8 inch)
3.
Grass-deflector bracket
7.
Short standoff
4.
Rod
2.
Slide the rod out of the short standoff, the spring, and
the grass deflector (
3.
Remove the damaged or worn grass deflector.
4.
Replace the grass deflector (
).
5.
Slide the rod (straight end), through the
rear-grass-deflector bracket.
6.
Place the spring on the rod, with the end wires down
and between the grass deflector brackets.
7.
Slide rod through the second grass-deflector bracket
(
).
8.
Insert the rod at the front of the grass deflector into
the short standoff on the deck.
9.
Secure the rear end of the rod into the mower with a
nut (3/8 inch) as shown in
Important:
The grass deflector must be spring
loaded and in the down position. Lift the deflector
up to test that it snaps to the full down position.
48
Summary of Contents for timecutter zs 4200t
Page 55: ...Schematics Electrical Diagram Rev A 55 ...
Page 56: ...Notes 56 ...
Page 57: ...Notes 57 ...
Page 58: ...Notes 58 ...
