Toro Mower Safety
The following list contains safety information specific to Toro
products and other safety information you must know.
This product is capable of amputating hands and feet, and
throwing objects. Always follow all safety instructions to
avoid serious injury or death.
This product is designed for cutting and recycling grass, or,
when equipped with a grass bagger, for catching cut grass.
Any use for purposes other than these could prove dangerous
to the user and bystanders.
General Operation
•
Be sure that the area is clear of bystanders before mowing.
Stop the machine if anyone enters the area.
•
Do not touch equipment or attachment parts which may
be hot from operation. Allow all of the parts to cool
before attempting to maintain, adjust, or service the
machine.
•
Use only Toro-approved attachments. Warranty may be
voided if used with any unapproved attachments.
•
Check carefully for overhead clearances (i.e. branches,
doorways, electrical wires, etc.) before operating under
any objects, and do not contact them.
•
Slow down before making turns and use extra caution.
•
Use caution when riding the platform over curbs, rocks,
roots, or other obstructions.
•
Look behind and down before backing up to ensure a
clear path. Use extra care when operating in reverse.
•
Do not jerk the controls; use a steady motion.
•
When loading or unloading the machine, use one
full-width ramp that is wide enough to extend beyond
the width of the machine.
•
Do not carry passengers.
•
Do not carry equipment on the machine.
Slope Operation
All slopes and ramps require extra caution. If you feel uneasy
on a slope, do not mow it.
•
Remove obstacles such as rocks, tree limbs, etc. from the
mowing area.
•
Watch for holes, ruts or bumps.
Note:
Tall grass can hide obstacles.
•
Use caution near drop-offs, ditches, or embankments.
Note:
The machine could suddenly turn over if a wheel
goes over the edge of a cliff or ditch, or if an edge caves in.
•
Use extra care with grass catchers or other attachments.
Note:
These can change the stability of the machine.
•
Keep all movement on slopes slow and gradual.
•
Do not make sudden changes in speed or direction.
•
Mow slopes side to side.
•
Do not mow slopes greater than 15 degrees.
Towing Safety
•
Do not attach towed equipment except at the hitch point.
•
Follow the attachment manufacturer's recommendation
for weight limits for towed equipment and towing on
slopes. Towed weight must not exceed the weight of the
machine, operator, and ballast. Use counterweights or
wheel weights as described in the attachment, or in the
pulling machine
Operator’s Manual
.
•
Never allow children or others in or on towed equipment.
•
On slopes, the weight of the towed equipment may cause
loss of traction, increased risk of rollover, and loss of
control. Reduce the towed weight and slow down.
•
Stopping distance increases with the weight of the towed
load. Travel slowly and allow extra distance to stop.
•
Make wide turns to keep the attachment clear of the
machine.
Service
•
Do not store the machine or a fuel container inside where
there is an open flame, such as near a water heater or
furnace.
•
Keep the nuts and bolts tight, especially the
blade-attachment bolts.
•
Never remove or tamper with safety devices. Check their
proper operation regularly. Never do anything to interfere
with the intended function of a safety device or to reduce
the protection provided by a safety device.
•
Removing standard original equipment parts and
accessories may alter the warranty, traction, and safety
of the machine. Failure to use original Toro parts could
cause serious injury or death. Making unauthorized
changes to the engine, fuel or venting system, may violate
regulations.
6
Summary of Contents for timecutter zs 4200t
Page 55: ...Schematics Electrical Diagram Rev A 55 ...
Page 56: ...Notes 56 ...
Page 57: ...Notes 57 ...
Page 58: ...Notes 58 ...
