35
m–8126
7
4
2
5
6
3
1
Figure 47
1. Mower bracket
2. Spring, hooked ends
down
3. Spacer
4. Grass deflector
5. Bolt
6. Locknut
2.
Align the grass deflector with the holes in the brackets
and the spring and spacer straight ends in the space
between the brackets and above the deflector (Fig. 47).
3.
Place the spring and spacer so that the hooked ends of
the spring are pointing down, with one end contacting
on the mower deck and the other over the deflector
(Fig. 47).
4.
Secure the deflector to the mower bracket with the bolt.
The bolt should pass through the grass deflector, spring,
spacer, and brackets. Secure with the locknut.
Note:
It may be helpful to press down near the end of the
bolt with a 9/16 inch open end wrench to align the bolt with
the second hole on the mower bracket and grass deflector.
5.
Lift the grass deflector and check that it is spring loaded
and pivots freely to the full down position.
Important
The grass deflector must be spring loaded in
the down position. Lift the deflector up to test that it snaps
to the full down position.
Summary of Contents for TimeCutter ZX480
