Toro TimeCutter ZX480, Operator'S Manual

37

Cleaning and Storage

1.

Disengage the PTO, set the parking brake, stop the

engine, and remove the key.

2.

Remove grass clippings, dirt, and grime from the

external parts of the entire machine, especially the

engine. Clean dirt and chaff from the outside of the

engine cylinder head fins and blower housing.

Important

You can wash the machine with mild

detergent and water. Do not pressure wash the machine.

Avoid excessive use of water, especially near the control

panel, engine, hydraulic pumps, and motors.

3.

Service the air cleaner; refer to Servicing the Air

Cleaner, page 22.

4.

Grease and oil the machine; refer to Greasing and

Lubrication, page 26.

5.

Change the crankcase oil and filter; refer to Servicing

the Engine Oil, page 21.

6.

Check the tire pressure; refer to Checking the Tire

Pressure, page 29.

7.

Charge the battery; refer to Servicing the Battery,

page 26.

8.

Check the condition of the blades; refer to Servicing the

Cutting Blades, page 24.

9.

Prepare the machine for storage when non-use occurs

over 30 days. Prepare the machine for storage as

follows.

10.

Add a petroleum based stabilizer/conditioner to the fuel

in the tank. Follow the mixing instructions from the

stabilizer manufacturer. 

Do not use an alcohol based

stabilizer (ethanol or methanol).

Note:

 A fuel stabilizer/conditioner is most effective when

mixed with fresh gasoline and used at all times.

A. Run the engine to distribute the conditioned fuel

through the fuel system (5 minutes).

B. Stop the engine, allow it to cool, and drain the fuel

tank; refer to Draining the Fuel Tank, page 29.

C. Restart the engine and run it until it stops.

D. Choke or prime the engine. Start and run the engine

until it will not start. Operate the primer, if

equipped, several times to ensure no fuel remains in

the primer system.

E. Dispose of fuel properly. Recycle as per local codes.

Important

Do not store stabilizer/conditioned gasoline

over 90 days.

11.

Remove the spark plug(s) and check its condition; refer

to Servicing the Spark Plug, page 23. With the spark

plug(s) removed from the engine, pour two tablespoons

of engine oil into the spark plug hole. Use the starter to

crank the engine and distribute the oil inside the

cylinder. Install the spark plug(s). Do not install the

wire on the spark plug(s).

12.

Clean any dirt and chaff from the top of the mower.

13.

Scrape any heavy buildup of grass and dirt from the

underside of the mower, then wash the mower with a

garden hose.

14.

Check the condition of the drive and mower belts.

15.

Check and tighten all bolts, nuts, and screws. Repair or

replace any part that is worn or damaged.

16.

Paint all scratched or bare metal surfaces. Paint is

available from your Authorized Service Dealer.

17.

Store the machine in a clean, dry garage or storage area.

Remove the key from the ignition switch and keep it in

a memorable place. Cover the machine to protect it and

keep it clean.