G008952
Figure 25
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, look behind you and down as
you slowly pull the motion control levers rearward
(Figure 26).
G008953
Figure 26
Stopping the Machine
To stop the machine, move the traction control levers
to neutral and move to locked position, disengage the
blade control switch (PTO), and turn the ignition key
to off.
Set the parking brake when you leave the machine; refer
to Setting the Parking Brake. Remember to remove the
key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Adjusting the Height of Cut
The machine is equipped with a foot pedal deck lift
system. The operator can use the foot pedal to lift
the deck briefly to avoid obstacles or lock the deck in
the highest height-of-cut or transport position. The
operator can use the height of cut lever with the foot
pedal to lock the deck in a specific cutting height.
Using the Foot Pedal Deck Lift System
Press the pedal down to raise the deck; continue to
press the pedal until the deck is locked in the transport
position Figure 27. Push on the deck lift pedal with
your foot and raise the height-of-cut lever slightly to
disengage the transport lock.
25
Summary of Contents for TITAN ZX5020
Page 54: ...Schematics G010474 Wire Diagram Rev A 54 ...
Page 55: ...Notes 55 ...
