Operation
14
Setting the Height-of-Cut
The height-of-cut lever (deck lift) is used to raise and
lower the mower to the desired cutting height.
1.
The cutting height may be set in one of seven
positions from approximately 1
to 4
inches
(38 to 116 mm).
2.
Pull on the height-of-cut lever (deck lift) and
move it to the desired position (Fig. 8).
1
1–1/2” (38 mm)
1” (25 mm)
2” (51 mm)
2–1/2” (64 mm)
3” (76 mm)
3–1/2” (89 mm)
4” (102 mm)
Approximately
1853
Figure 8
1. Height-of-cut lever (deck lift)
Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1.
Raise the seat and loosen the adjustment knob
(Fig. 9).
2.
Move the seat to the desired position and tighten
the knob.
1
1862
Figure 9
1. Adjustment knob
Summary of Contents for Wheel Horse 16-44 HXLE
