16
Danger
You could back over a child or bystander while the
mower blade or other attachment is engaged and
cause serious injury or death.
•
Do not mow in reverse unless it is absolutely
necessary.
•
Do not insert the KeyChoice key unless it is
absolutely necessary.
•
Always look backward and down before
backing up the tractor.
•
Use the KeyChoice switch only if you are certain
that no children or other bystanders will enter
the mowing area.
•
Be very observant after deactivating the
interlock because the sound of the engine may
prevent you from noticing that a child or
bystander has entered the work area.
•
Always remove both the ignition and KeyChoice
keys and put them in a safe place out of the
reach of children or unauthorized users when
you leave the tractor unattended.
1. Engage the blade (PTO).
2. Insert the KeyChoice key into the switch (Fig. 10).
1
mĆ4157
Figure 10
1.
KeyChoice switch
3. Turn the KeyChoice key.
A red light on the front console (Fig. 11) turns on,
indicating that the interlock is disabled.
m-1863
1
Figure 11
1.
Operating-in-reverse light
4. Shift the ground speed lever into Reverse and complete
your task.
5. Disengage the blade (PTO) to activate the interlock.
6. Remove the KeyChoice key and put it in a safe place
out of the reach of children.
Testing the Safety Interlock
System
If the safety interlock switches are disconnected or
damaged, the tractor could operate unexpectedly,
causing personal injury.
•
Do not tamper with the interlock switches.
•
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the tractor.
Caution
Test the safety interlock system before you use the tractor
each time. If the safety interlock system does not operate as
described below, have an Authorized Service Dealer repair
the safety interlock system immediately. While sitting in
the seat, perform the following checks:
1. Shift the ground speed lever into Neutral, set the
parking brake, shift the blade control (PTO) lever to
Engage, and turn the ignition key to Start: The engine
should not crank.
2. With the ground speed lever in Neutral, shift the blade
control (PTO) lever to the Disengage position, release
the parking brake, and turn the ignition key to Start:
The engine should not crank.
