Fuel System
Maintenance
Replacing the Fuel Filter
Service Interval:
Every 400 hours
1.
Raise the bed (if equipped), and place the safety support
on the extended-lift cylinder to hold up the bed.
2.
Place a clean container under the fuel filter (
).
Figure 44
1.
Fuel filter
3.
Loosen the R-clamp securing the filter to the frame.
4.
Remove the clamps securing the fuel filter to the fuel
lines.
5.
Install a new fuel filter to fuel lines with the clamps
previously removed.
Note:
The filter must be mounted so the arrow points
toward the carburetor.
6.
Tighten the R-clamp securing the filter to the frame.
7.
Wipe up and spilled fuel.
Inspecting the Fuel Lines and
Connections
Service Interval:
Every 400 hours/Yearly (whichever comes
first)
Every 1,000 hours/Every 2 years (whichever comes
first)
Inspect the fuel lines and connections for deterioration,
damage, or loose connections.
Electrical System
Maintenance
Servicing the Fuses
The fuses for the electrical system are located under the
center of the dash panel (
and
Figure 45
1.
Fuses
Figure 46
1.
Power outlet—10 A
5.
Lights, brake—15 A
2.
Switched power—10 A
6.
Hazard—10 A
3.
Fuel pump, supervisor
switch—10 A
7.
4WD, Transmission—10 A
4.
Horn, power point—15 A
41
Summary of Contents for Workman HD 07369
Page 55: ...Notes 55...
