Adjusting the Height of Cut
Using the Transport Lock
The transport lock has 2 positions, and is used with
the deck-lift pedal. There is a L
OCK
position and a
U
NLOCK
position for the transport position (
).
g032377
Figure 27
Transport-Lock Positions
1.
Transport lock
3.
U
NLOCK
position—does
not lock the mower deck
into transport position
2.
L
OCK
position—mower
deck locks into transport
position
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1.
Move the transport lock to the lock position.
2.
Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
3.
To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket (
4.
Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (
5.
Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
g027343
Figure 28
1.
Deck-lift pedal
3.
Transport lock
2.
Cut-of-height pin
30
Summary of Contents for Z Master Professional 5000 Series
Page 13: ...decal136 5508 136 5508 1 Belt routing 13...
Page 78: ...Schematics g021490 Wire Diagram Rev A 78...
Page 79: ...Notes...
