Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Change the engine oil.
After the first 100 hours
• Check the wheel lug-nut torque.
• Check the wheel-hub slotted-nut torque.
• Check the parking brake adjustment.
After the first 250 hours
• Change the hydraulic filters and hydraulic fluid when using any type of fluid.
Before each use or daily
• Check the safety system.
• Check the engine-oil level.
• Check the LPG tank and components.
• Check the seat belt.
• Check the rollover protection system (ROPS) knobs.
• Clean the engine screen and the oil cooler.
• Check and clean the hydraulic-unit shrouds.
• Inspect the blades.
• Clean under the mower deck.
Every 40 hours
• Check the LPG hoses, regulator, and connections.
Every 50 hours
• Check the spark arrester (if equipped).
• Check the tire pressure.
• Inspect the belts for cracks and wear.
• Check the hydraulic-fluid level.
Every 100 hours
• Lubricate the mower deck-lift pivots.
• Change the engine oil (more often in dirty or dusty conditions).
• Check and clean engine-cooling fins and shrouds.
Every 150 hours
• Inspect the primary filter and the air-inlet screen.
Every 200 hours
• Change the engine-oil filter.
• Check, clean and regap the spark plug.
Every 250 hours
• Change the hydraulic filters and hydraulic fluid when using Mobil® 1 fluid (more
often in dirty or dusty conditions).
Every 300 hours
• Replace the primary air filter (more often in dusty or sandy conditions).
• Check the inner air filter.
Every 500 hours
• Check the wheel lug-nut torque.
• Check the wheel-hub slotted-nut torque.
• Adjust the caster-pivot bearings.
• Check the parking brake adjustment.
• Change the hydraulic filters and hydraulic fluid when using Toro® HYPR-OIL™ 500
hydraulic fluid (more often in dirty or dusty conditions).
Every 600 hours
• Replace the inner air filter.
Monthly
• Check the battery charge.
Yearly
• Grease the pump-belt-idler arm.
• Grease the front caster pivots (more often in dirty or dusty conditions).
• Repack the front caster-wheel bearings (more often in dirty or dusty conditions).
• Lubricate the caster-wheel hubs.
Yearly or before storage
• Paint chipped surfaces.
• Check all maintenance procedures listed above before storage.
Important:
Refer to your engine operator's manual for additional maintenance procedures.
37
Summary of Contents for Z Master Professional 5000 Series
Page 13: ...decal136 5508 136 5508 1 Belt routing 13...
Page 78: ...Schematics g021490 Wire Diagram Rev A 78...
Page 79: ...Notes...
