Using the Side Discharge
Machines with Side Discharge
Only
The mower has a hinged grass deflector that
disperses clippings to the side and down toward the
turf.
DANGER
Without a grass deflector, discharge cover, or
a complete grass-catcher assembly mounted
in place, you and others are exposed to blade
contact and thrown debris. Contact with
rotating mower blade(s) and thrown debris
will cause injury or death.
•
Never remove the grass deflector from the
mower deck because the grass deflector
routes material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the
mower deck.
•
Never try to clear the discharge area
or mower blades unless you move the
blade-control switch (PTO) to the O
FF
position, rotate the key switch to the O
FF
position, and remove the key from the key
switch.
•
Make sure that the grass deflector is in the
down position.
Adjusting the Height of Cut
Adjust the height of cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1.
Raise the height-of-cut lever to the T
RANSPORT
position (also the 127 mm (5 inch) cutting-height
position) (
).
g009568
Figure 28
1.
Height-of-cut lever
2.
Pin
2.
To adjust, remove the pin from the height-of-cut
bracket (
).
3.
Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, and
insert the pin (
4.
Move the lever to the selected height.
29
Summary of Contents for Z Master Professional 7000 Series
