g006530
Figure 101
1.
Cutting edge
3.
Wear/slot forming
2.
Curved area
4.
Crack
Checking for Bent Blades
Note:
The machine must be on a level surface for
the following procedure.
1.
Raise the mower deck to the highest
height-of-cut position.
2.
While wearing thickly padded gloves, or other
adequate hand protection, slowly rotate the
blade into a position that allows you to measure
the distance between the cutting edge and the
level surface the machine is on (
).
g014972
Figure 102
1.
Deck
3.
Blade
2.
Spindle housing
3.
Measure from the tip of the blade to the flat
surface (
).
g014973
Figure 103
1.
Blade (in position for measuring)
2.
Level surface
3.
Measured distance between blade and the surface (A)
4.
Rotate the same blade 180 degrees so that
the opposing cutting edge is now in the same
position (
g014974
Figure 104
1.
Blade (side previously measured)
2.
Measurement (position used previously)
3.
Opposing side of blade being moved into measurement
position
5.
Measure from the tip of the blade to the flat
surface (
).
Note:
The variance should be no more than
3 mm (1/8 inch).
72
Summary of Contents for Z Master Professional 7000 Series
