25
2. Remove bracket pin (Fig. 25).
5
1
2
4
3
m–5599
Figure 25
1.
Z Stand
2.
Latch
3.
Bracket
4.
Bracket Pin
5.
Bottom of slot
3. Raise latch. Swing stand foot out front and slide stand
toward machine, into the bottom of slot
(Fig. 25 and 26).
4. Set foot of stand on the ground and rest latch on pivot
tab (Fig. 26).
5. Start engine and put at half throttle.
Note: For best results, place foot of stand into seams in
sidewalks or into turf (Fig. 26).
6. Drive onto stand. Stop when latch drops over tab into
locked position (Fig. 26). Once onto stand, engage
parking brake. Shut off engine.
7. Chock or block the drive wheels.
Parking brake may not hold machine parked on
Z Stand and could cause personal injury or
property damage.
Do not park on Z Stand unless wheels are chocked
or blocked.
Warning
8. Perform maintenance.
9. Remove chocks or blocks.
1
2
3
m–5600
Figure 26
1.
Z Stand (Positioned in
slot)
2.
Crack in side walk or turf
3.
Latch resting on pivot tab
Driving off the Z Stand
1. Raise latch to unlocked position (Fig. 27).
2. Start engine and place at half throttle. Disengage
parking brake.
3. Slowly drive backwards off of stand.
4. Return stand to its rest position (Fig. 25).
2
1
4
3
m–5601
Figure 27
1.
Z Stand
2.
Latch
3.
Locked position
4.
Unlocked position
Using the Lift Assist Lever
The lift assist lever is used along with the height-of-cut
lever for raising the deck. This allows for easier raising of
the deck.
1. Place your foot onto the lift assist lever.
2. Press on the lift assist while pulling up on the
height-of-cut lever (Fig. 28).
Summary of Contents for Z287L Z Master
Page 6: ...6 Slope Chart ...
Page 7: ...7 ...
Page 12: ...12 103 2433 106 6571 106 6570 ...
Page 55: ...55 ...
