24
3. Select hole in height-of-cut bracket corresponding to
the height-of-cut desired, and insert clevis pin
(Fig. 11).
4. Secure clevis pin with hairpin cotter (Fig. 11).
5. Move lever to selected height.
1
3
2
M-4164
Figure 11
1.
Height of cut lever
2.
Clevis Pin
3.
Hairpin Cotter
Adjusting Anti-Scalp Rollers
Whenever you change the height-of-cut it is
recommended to adjust the height of the anti-scalp rollers.
1. Disengage the power take off (PTO) and turn the
ignition key to “OFF” to stop the engine. Move levers
to neutral locked position and apply parking brake.
Remove the key.
2. After adjusting height-of-cut remove flange nut and
spring disk while holding stud with wrench (Fig. 12).
Note: Do not remove the wheel nut and washer (Fig. 12).
3. Select hole so gage wheel is positioned to the nearest
corresponding height-of-cut desired (Fig. 12).
4. Reinstall the flange nut and spring disk (Fig. 12).
5. Repeat adjustment on other gage wheels.
m–4167
1
2
3
4
5
Figure 12
1.
Gage Wheel
2.
Stud
3.
Spring Disk
4.
Flange Nut
5.
Wheel nut and washer.
Do Not Remove.
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. To adjust, move the lever sideways to unlock seat (Fig.
13).
2. Slide the seat to the desired position and release lever
to lock in position.
1
m–3655
Figure 13
1.
Adjustment lever
.
Pushing the Machine by Hand
Important
Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
