Important:
To adjust, move the lever sideways to
unlock seat (Figure 24).
Slide the seat to the desired position and release lever
to lock in position.
G000949
1
Figure 24
1.
Adjustment lever
Unlatching the Seat
Push the seat latch rearward to unlatch the seat.
This will allow access to the machine under the seat
(Figure 25).
G000950
1
2
3
Figure 25
1.
Seat latch
3.
Seat
2.
Fuel cap
Pushing the Machine by Hand
Important:
Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move the levers to neutral locked
position and apply parking brake. Remove the key.
2. Rotate the by-pass valves counterclockwise 1 turn
to push. This allows hydraulic fluid to by-pass the
pump enabling the wheels to turn (Figure 26).
Important:
Do not rotate by-pass valves more
than 1 turn. This prevents valves from coming
out of the body and causing fluid to run out.
3. Disengage parking brake before pushing.
Changing to Machine Operation
Rotate the by-pass valves clockwise 1 turn to operate
machine (Figure 26).
Note:
Do not over tighten the by-pass valves.
The machine will not drive unless by-pass valves are
turned in.
G000966
3
2
2
1
Figure 26
1.
Side console controls
3.
Hydraulic pumps
2.
By-pass valve
Using the Side Discharge
The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
25
