1
2
G001158
3
4
Figure 60
1.
Pump drive belt
3.
Spring loaded idler pulley
2.
Clutch
4.
Spring
Replacing and Tensioning the
Alternator Belt
Replacing the Alternator Belt
Service Interval:
Every 50 hours
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the 4 bolts holding the oil cooler shield to
the rear frame (Figure 61).
4. Remove the 3 bolts holding the engine straps to the
side of the machine (Figure 61).
G001295
1
2
3
2
Figure 61
1.
Oil cooler shield
3.
Engine straps
2.
Bolts
5. Remove the 4 bolts holding the oil cooler and
position the oil cooler to the side (Figure 62).
6. Remove the 2 bolts holding the fan and fan plate to
the machine (Figure 62).
G001296
1
2
3
4
Figure 62
1.
Oil cooler
3.
Fan plate
2.
Fan
4.
Alternator belt
7. Loosen the bottom bolt and remove the upper bolt
holding the alternator and cover (Figure 63).
8. Rotate the alternator cover to the side and remove
the belt from the pulleys and alternator.
9. Install a new belt around the pulleys and the
alternator (Figure 63).
10. Install the fan and fan plate to the machine with the
2 bolts previously removed (Figure 62).
11. Install the oil cooler with the 4 bolts previously
removed (Figure 62).
46
