COMMANDER XT1000 / XT2000
User Manual
Rev 1.06
40 |
P a g e
GETTING STARTED WITH THE COMMANDER
The Commander is as easy and convenient to use in the field as it is powerful. But with these
few simple steps, it’s even easier to get started.
1. The Digital Pressure Gauge and the Commander have already been paired through
Bluetooth. Review the section on
Pairing and Managing a Bluetooth Device
on page 24
for further assistance.
All that is needed is to establish communication between the two.
2. Press the
RED
Power Button
on the display face of the Digital Pressure Gauge to power it
on. The Gauge will establish the communication with the COMMANDER and it will display
the current pressure without transmitting data. You can set the pump using the pressure
display. (Digital Pressure Gauge battery is reduced by not using the Bluetooth)
3. It is best to start the Bluetooth transmission just before you ready to start the bolting job.
Just before you are to begin the job, press
START
button on the display face of the Digital
Pressure Gauge and it will immediately begin data transmission. You can now tap
START
on the COMMANDER to begin collecting the data the Digital Pressure Gauge is transmitting.
The Bluetooth communication is usually good to 40 feet provided there is a clean line of
sight. Obstacles and high frequency electrical sources can interrupt the transmission. It will
re-establish the connection on its own. If necessary, simply tap
CONNECT
on the Data
Collection screen to re-establish connection.
