84
Deutsch
English
6. Dismantling
1. Remove magnetic key from remote throttle (Cruise R)/tiller (Cruise T) and switch off
motor completely by pressing „on/off” button on the display. Set the battery main
switch to the off or neutral position.
2. Unplug connection between motor, cable set, and remote throttle (Cruise R)/ tiller
(Cruise T).
3. Unhinge the motor and place it on a flat surface.
• The pylon may be hot.
• Make sure the motor is dry before you store it.
• Ensure you do not bend the cable around sharp edges.
7. Storage and care instructions
7.1 Corrosion protection
Materials were chosen with a high level of corrosion-resistance. Most of the materials
used in the Cruise are, as with most leisure maritime products, classed as “seawater
resistant”, not “seawater-proof”.
• After use, you should always take the motor out of the water.
You can do this using the tilt mechanism of the transom bracket.
• After use in salt or brackish water rinse the motor with fresh water.
• Only store the motor in a dry condition.
• On a regular basis, maintain the contacts of the Cruise cable set.
• In order to ensure a lasting ease of motion of the remote throttle arm,
we recommend to apply lubricant (WD40 etc.) in the area between the
remote throttle arm and the remote throttle base.
