9.5 FIREPLACE OPERATION
Keep indoor unit’s fan blowing continuously during thermo off, to circulate
heat from other sources over the room. There are three setting parameters:
Default setting > Fireplace 1 > Fireplace 2
Fireplace 1:
●
During thermo off period, the indoor unit’s fan will continue to run by the
same speed, previously selected by end-user.
Fireplace 2:
●
During thermo off period, the indoor unit’s fan will continue to run at
super-low speed, programmed from factory.
Fireplace Operation Setting
1. Press MENU button for enter menu setting and press TEMP. button to
select FIREPLACE
MENU
MEN
°C
Blink both triangle and
feature mark Feature not
yet set
2. Enter FIREPLACE set by press MENU button.
triangle mark will stop blink and setting feature will be blink instead.
MENU
MEN
°C
3. Select FIREPLACE operation by press TEMP. button.
°C
FIREPLACE 1
FIREPLACE 2
None
4. Con
fi
rm selected feature by press MENU button again.
MENU
MEN
°C
Blink only triangle Feature
already set
When feature had selected will return to menu selection display triangle mark
will blink
5. Leave from menu setting display by select EXIT.
MENU
MEN
°C
Note:
●
While Fireplace operation on heating mode, indoor unit fan always runs and
cold air breezing might be occurred.
●
Fireplace will operate in Heating mode only.
9.6 TIMER OFF OPERATION
To set the timer OFF when the air conditioner is operating.
1. Press MENU button for enter menu setting and press TEMP. button to
select TIMER OFF.
MENU
MEN
°C
Blink both triangle and
feature mark Feature not
yet set
2. Enter TIMER set by press MENU button.
triangle mark will stop blink and setting feature will be blink instead.
MENU
MEN
3. Select TIMER OFF by press TEMP. button.
Can select TIMER OFF from 0.5 - 12hrs.
4. Con
fi
rm TIMER OFF by press MENU button.
MENU
MEN
°C
Blink only triangle
Feature already set
5. Leave from menu setting display by select EXIT.
MENU
MEN
°C
Note:
●
The setting will be saved for the next same operation.
Cancel TIMER OFF
6. During TIMER OFF already set (no.5) press MENU button and press
TEMP. button to select TIMER OFF.
MENU
MEN
°C
Blink only triangle
Feature already set
7. Press MENU button again will cancel TIMER OFF.
MENU
MEN
°C
Blink both triangle and feature
mark Feature not yet set
8. Leave from menu setting display by select EXIT.
MENU
MEN
°C
EN
Book_01_OM_1129850205_EN.indd 7
Book_01_OM_1129850205_EN.indd 7
22/3/2564 BE 19:41
22/3/2564 BE 19:41