44
1600Xp Series installation and operation manual
Changing UPS Parameter Settings
press the parameter to be changed and the display will open with an appropriate data entry screen.
Settings that cannot be changed will respond with “item cannot be changed” shown at the bottom of this
page.
Some parameters will display one of a set of fixed values, such as example 1.
example 1:
the UpS can have either one or two input lines. the value displayed
in the Active Value box is the parameter in use. Alternate values are
displayed in keys below the Active Value box.
After selecting the parameter value, press
Write
to write the entered
value to the UpS memory and return to the original parameter screen.
Some parameters can be any of a range of values, such as rated Volt-
age in example 2.
example 2:
the rated Voltage in can vary over a range. press the “rated Vin” pa-
rameter listing and enter the correct value in the Active Value box. using
the standard alphanumeric keypad.
Use the back arrow to delete an incorrect keystroke.
After changing the parameter value, press
Write
to write the entered
value to the UpS memory.
Some parameters are informational, some can be changed by the user,
and others can only be changed by a higher security access. if a param-
eter cannot be changed under the current security access level, selecting
the parameter for change will generate the message
“Item cannot be
changed”
.
press
OK
to return to the original display.
on-line
Main
Monitor
Settings
Records
12:35 pm
inV
HOME
USR
Quit
Write
102 No of Input Line
240V
230V
5JKL
8TUV
0-:
208V
4GHI
7PQRS
240V
6MNO
9WXYZ
Shift
on-line
Main
Monitor
Settings
Records
12:35 pm
inV
HOME
USR
Quit
Write
117 VIUV Hysteresis*
8
2 ABC
5JKL
8TUV
0-:
1./
4GHI
7PQRS
3DEF
6MNO
9WXYZ
Shift
on-line
dVCoH
ASyn
Main
Monitor
Settings
Records
12:35 pm
init
HOME
USR
1 / 32
Item cannot be changed
OK
96%
100%
96%
100%
96%
100%
