70
1600Xp Series installation and operation manual
refer to Figure 1 for location of UpS referenced material. refer to Figure 2 for material referring to the
receptacle panel module. there are different panels available depending on the UpS typeform.
Step 1: remove the modular receptacle panel cover plate.
on the rear of the UpS, locate the cover plate for the receptacle panel module interface
(see Figure 1).
remove the 6 mounting screws.
remove the cover plate. A square-shaped plug will be exposed.
Step 2: Snap-in output receptacle modular panel.
Carefully mate the square-shaped connector on the UpS to its matching counter part on the rear of the
modular panel.
Step 3: mount the receptacle panel.
Attach the screws removed from the cover plate through the mounting holes of the receptacle panels and
back into the UpS mounting points.
Figure 1
Figure 2
