8
Remote control
(continued)
Install the batteries
Use batteries type UM4/R03 (AAA-Size).
Notes:
• Exhausted batteries can leak corrosive electrolyte, which may cause damage to the remote control - therefore remove
exhausted batteries immediately.
• Do not use old or weak batteries. The remote control may not work properly with a weak voltage from such batteries. Replace
exhausted batteries with new ones. Never try to recharge normal batteries - this could cause an explosion.
• Dispose of batteries in a designated disposal area.
Warnings:
• Never throw batteries into a fire.
• Never expose batteries to excessive heat such as sunshine, fire or the like.
Distance of remote control operation
The remote control handset will not work properly in the following cases:
1
Open the battery compartment cover
in the direction of the arrow.
2
Install the batteries as shown
below, ensuring the correct polarity.
3
Close the battery compartment.
If bright sunlight directly beams onto the unit front.
If an obstacle is placed between the unit and the handset.
If the batteries have not been installed according
to their polarities.
If the batteries are weak.
