1-5: DVD MT PCB and DVD DECK (Refer to Fig. 1-5)
1-6: POWER PCB (Refer to Fig. 1-6)
1. Put the Cabinet Back Ass'y on the bottom.
1. Disconnect the following connector:
(CP3902 and CP3903)
2. Short circuit the position shown in Fig. 1-5 using a
2. Remove the 2 screws (1).
soldering iron. If you remove the DVD Deck with no
3. Remove the Sheet PC in the direction of arrow (A).
soldering, the Laser may be damaged.
4. Remove the 4 screws (2).
3. Disconnect the following connectors:
5. Remove the Power PCB in the direction of arrow (B).
(CP2301, CP2303, CP2304, CP8501 and CP8502).
4. Remove the 2 screws (1).
5. Remove the DVD DECK Ass'y in the direction of
arrow (A).
6. Remove the 2 screws (2).
7. Remove the Angle MPEG in the direction of arrow (B).
8. Remove the 4 screws (3).
9. Remove the DVD MT PCB in the direction of arrow (C).
DISASSEMBLY INSTRUCTIONS
(1)
(1)
Power PCB
(A)
(2)
(2)
(B)
Back Cabinet Ass'y
Fig. 1-6
(2)
Sheet PC
(1)
(A)
(2)
(1)
(B)
(C)
(3)
(3)
(3)
(3)
Angle MPEG
DVD Deck
Pick Up PCB
(2)
(2)
CP2301
CP2303
CP2304
CP3903
CP3902
CP8502
CP8501
DVD MT PCB
B1-5
26LV61K
1-7: DIGITAL PCB (Refer to Fig. 1-7)
1. Disconnect the following connector:
(CP301, CP6201, CP6202 and CP6204).
2. Remove the 7 screws (1).
3. Remove the Digital PCB in the direction of arrow.
NOTE
1. Before your operation, please read "PREPARATION
OF SERVICING".
2. Use the Lead Free solder.
3. Manual soldering conditions
• Soldering temperature: 320 ± 20
o
C
• Soldering time: Within 3 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4. When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux
smoke away from it.
5. When installing the DVD Deck, remove all the soldering
on the short circuit position after the connection of Pick
Up PCB and DVD MT PCB connector.
(1)
(1)
Digital PCB
Back Cabinet Ass'y
Fig. 1-7
Fig. 1-6
(1)
(1)
(1)
(1)
(1)
(A)
Fig. 1-5
Back Cabinet Ass'y
Short circuit using a
soldering iron.
CP6204
CP301
CP6201
CP6202
B1-5
26LV61K
