2. REMOVAL OF DVD DECK PARTS
NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the disassembly
is done. If the repair is needed except listed parts, replace
the DVD MECHA ASS'Y.
2-1: TRAVERSE ASS'Y (Refer to Fig. 2-1-A)
1. Remove the 3 screws (1).
2. Unlock the 2 supports (2).
3. Remove the Insulator (R) from the Loader Sub Ass'y.
2-2: SWITCH PCB ASS'Y/GEAR MIDDLE/GEAR FEED/
4. Remove the Traverse Ass'y.
RACK FEED ASS'Y/FEED MOTOR (Refer to Fig. 2-2-A)
1. Remove the Insulator (F).
2. Remove the Insulator (R).
3. Unlock the support (1).
4. Remove the Gear Middle.
5. Remove the screw (2).
6. Remove the Rack Feed Ass'y.
7. Remove the screw (3).
8. Remove the Switch PCB Ass'y.
9. Remove the screw (4).
10. Remove the Gear Feed.
11. Remove the 2 screws (5).
12. Remove the Feed Motor.
DISASSEMBLY INSTRUCTIONS
(2)
(2)
(1)
(1)
Traverse Ass'y
Loader Sub Ass'y
Insulator (R)
Check Hook
Check Hook
Check Hook
Fig. 2-1-D
Loader Ass'y (Top Side)
12. Remove the Feed Motor.
• Screw Torque: 2.0 ± 0.3kgf•cm
13. Remove the Gear Motor.
NOTE
1. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-1-B to Fig. 2-1-C.
• Screw Torque: 1.3 ± 0.3kgf•cm (Screw 2)
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw 3)
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw 4, 5)
80 ± 5mm
(1)
(1)
Fig. 2-1-A
Loader Ass'y (Bottom Side)
Check Hook
Check Hook
Check Hook
Fig. 2-1-B
Check Hook
Loader Ass'y
Fig. 2-1-C
Feed Motor
Insulator (R)
Traverse Ass'y
Gear Motor
Insulator (F)
Insulator (F)
(5)
(5)
Gear Feed
Fig. 2-2-A
(1)
Rack Feed Ass'y
(4)
(2)
Gear Middle
Switch PCB Ass'y
(3)
B2-1
19LV61K/26LV61K
